Transport, Packaging And Storage - WIKA TFS135 Mode D'emploi

5. Transport, packaging and storage

5. Transport, packaging and storage
5.1 Transport
Check the bimetal temperature switch for any damage that may
have been caused by transport. Obvious damage must be reported
immediately.
5.2 Packaging
Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection during
transport (e.g. change in installation site, sending for repair).
5.3 Storage
Permissible conditions at the place of storage:
Storage temperature: -40 ... +85 °C
■
Humidity: 35 ... 85 % relative humidity (no condensation)
■
Avoidance of exposure to the following factors:
Direct sunlight or proximity to hot objects
■
Mechanical vibration, mechanical shock (putting it down hard)
■
Soot, vapour, dust and corrosive gases
■
Potentially explosive environments, flammable atmospheres
■
Store the bimetal temperature switch in its original packaging in
a location that fulfils the conditions listed above. If the original
packaging is not available, pack and store the temperature switch as
described below:
1. Wrap the temperature switch in an antistatic plastic film.
2. Place the temperature switch, along with shock-absorbent material,
in the packaging.
3. If stored for a prolonged period of time (more than 30 days), place a
bag containing a desiccant inside the packaging.
WIKA operating instructions model TFS135
All manuals and user guides at all-guides.com
EN
11