Safety Symbols - Dremel 220 Consignes De Fonctionnement/Sécurité

DM 2610921728_220 4/12/16 11:16 AM Page 7
The definitions below describe the level of severity for each signal word. Please read the manual
!
injury.
SAVE ALL WARNINGS AND INSTRUCTIONS FOR FUTURE REFERENCE
The term "power tool" in the warnings refers to your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
Disconnect the plug from the power
source and/or the battery pack from the
power tool before making any adjustments
or changing accessories. Accidental starting
of the power tool is a cause of some
accidents.
Properly assemble the workstation before
mounting the power tool. Proper assembly
is important to prevent risk of collapse.
Securely fasten the power tool to the
workstation before use. Power tool shifting
in the workstation can cause loss of control.
Place the workstation on a solid, flat and
level surface. When the workstation can shift
or rock, the power tool or workpiece cannot be
steadily and safely controlled.
Securely fasten workstation to a stable
platform or workbench. During operation
unstable platforms or workbenches may shift
or tip causing loss of control and injury.
Know how to shut off the power tool!
Position the power tool so that switch is
readily accessible to quickly shut off in an
emergency.
Route the cord away from the bit or cutting
area. Cutting into live electrical wires may
result in a shock, burn or electrocution.

Safety Symbols

and pay attention to these symbols.
This is the safety alert symbol. It is used to alert you to potential
personal injury hazards. Obey all safety messages that follow this
symbol to avoid possible injury or death.
DANGER indicates a hazardous situation which, if not avoided, will
result in death or serious injury.
WARNING indicates a hazardous situation which, if not avoided, will
result in death or serious injury.
CAUTION, used with the safety alert symbol, indicates a hazardous
situation which, if not avoided, will result in minor or moderate injury.
Safety Rules for Dremel Workstation
Read all safety warnings and all instructions. Failure to follow the
warnings and instructions may result in electric shock, fire and/or serious
Wear eye protection and dust mask. Use
only in well-ventilated area. Using personal
safety devices and working in safe
environment reduces risk of injury.
Do not wear gloves, necktie or loose
clothing during operation of the power
tool. Tie back long hair or use a hair net.
Clothing or hair can become caught in the
spinning bit and injury may occur.
Match the appropriate bit and its speed to
your application. Do not use bits that have
a cutting diameter that exceed the capacity
of the power tool. The workstation is
intended primarily for light duty use on wood.
Overloading the power tool can lead to
personal injury or power tool failure.
Never use dull or damaged bits. Sharp bits
must be handled with care. Damaged bits
can snap during use. Dull bits require more
force to push the workpiece, possibly causing
the bit to break.
Always make sure the workpiece is free
from nails and other foreign objects.
Cutting into a nail will damage the bit and can
cause the workpiece to jump causing loss of
control.
This workstation was designed for drilling,
-7-