Cleaning The Spray Arms; External Cleaning; Troubleshooting - Electrolux GA55SLI220 Notice D'utilisation

70 www.electrolux.com

9.2 Cleaning the spray arms

Do not remove the spray arms.
If the holes in the spray arms are clogged,
remove remaining parts of soil with a thin
pointed object.

9.3 External cleaning

Clean the appliance with a moist soft
cloth.

10. TROUBLESHOOTING

The appliance does not start or it stops
during operation.
Before you contact the Service, refer to
the information that follows for a solution
to the problem.
With some problems, intermittent
acoustic signals operates and the dis-
play shows a message.
Problem
The programme
does not start.
All manuals and user guides at all-guides.com
Possible cause
The mains plug is not con-
nected in the mains socket.
The appliance door is open.
The display shows the mes-
sage Close the door .
You did not press the OK
touchpad.
The fuse in the fuse box is
damaged.
The delay start is set.
6. Assemble the filter (A) and put it into
position in filter (B). Turn it clockwise
until it locks.
An incorrect position of the filters
can cause bad washing results
and damage to the appliance.
Only use neutral detergents. Do not use
abrasive products, abrasive cleaning pads
or solvents.
WARNING!
Deactivate the appliance before
you do the checks.
Possible solution
Connect the mains plug.
Close the appliance door.
Press the OK touchpad.
Replace the fuse.
Cancel the delay start or
wait for the end of the
countdown.