Cleaning The Spray Arms; Internal Cleaning; External Cleaning; Troubleshooting - Electrolux GA60SLI222 Notice D'utilisation

9.2 Cleaning the spray arms

Do not remove the spray arms.
If the holes in the spray arms are clogged,
remove remaining parts of soil with a thin
pointed object.

9.3 External cleaning

Clean the appliance with a moist soft
cloth.
Only use neutral detergents. Do not use
abrasive products, abrasive cleaning pads
or solvents.

10. TROUBLESHOOTING

The appliance does not start or it stops
during operation.
Before you contact the Service, refer to
the information that follows for a solution
to the problem.
Display
Attention: no intake of water possible.
Please ensure the tap is not closed or
blocked.
Attention: water is not draining. Please
ensure the drain tube is not attached
wrongly.
Attention: The antiflood system has been
activated.
WARNING!
Deactivate the appliance before
you do the checks.
All manuals and user guides at all-guides.com
6.
Make sure that the filter (B) is cor-
rectly positioned under the 2 guides
(C).
7.
Assemble the filter (A) and put it back
in filter (B). Turn it clockwise until it
locks.
An incorrect position of the filters
can cause bad washing results
and damage to the appliance.

9.4 Internal cleaning

If you regularly use short duration pro-
grammes, these can leave deposits of
grease and limescale inside the appliance.
To prevent this, we recommend to run
long duration programmes at least 2
times per month.
With some problems the display
shows a message.
Problem
The appliance does not fill with water.
The appliance does not drain the wa-
ter.
The anti-flood device is on.
ENGLISH 73