I.3.2 Information About Residual Risks That Cannot Be Eliminated; I.4 Description Of Controls; I.4.1 General Switch; I.4.2 Circuit Breaker Switches - emmeti EH Série Manuel D'installation Et D'utilisation

I.3.2 INFORMATION ABOUT RESIDUAL RISKS
THAT CANNOT BE ELIMINATED
IMPORTANT!
Pay the utmost attention to the signs and symbols
located on the appliance.
If any risks remain in spite of the provisions adopted, these are
indicated by adhesive labels attached to the machine in compliance
with standard "ISO 3864".
Indicates the presence of live components
Indicates the presence of moving parts
(belts, fans).
Indicates the presence of hot surfaces
(cooling circuit, compressor heads).
Indicates the presence of sharp edges on
finned coils
I.4 DESCRIPTION OF CONTROLS
The controls consist of the master switch, circuit breakerand user
interface panel.
I.4.1 GENERAL SWITCH
Manually controlled type "b" mains power supply disconnection device
(ref. EN 60204-1§5.3.2).
I.4.2 CIRCUIT BREAKER SWITCHES
Automatic compressor protection switch
This switch allows supplying or isolating the compressor's power circuit.
24
SECTION I: USER