Toro TurfMaster 22210 Manuel De L'utilisateur page 16

Operating the Self-Propel
Drive and Engaging the
Cutting Blades
To operate the self-propel drive, hold the drive bail
against the handle (Figure
Figure 19
To engage the cutting blades, do the following:
1. Push and hold the blade-control lock lever
forward to release the blade-control bail
20).
Figure 20
1. Blade-control lock lever
2. Locked position
3. Blade-control bail
2. Squeeze the blade-control bail against the
handle and release the blade-control lock lever;
the blade should engage.
3. Release the blade-control bail to disengage the
blade. The blade-control lock lever will reset to
lock the blade-control bail.
19).
(Figure
4. Push
5. Unlocked position
6. Squeeze against handle
Recycling the Clippings
This machine comes from the factory ready to recycle
grass and leaf clippings back into the lawn. To prepare
the machine to recycle:
•
If the side-discharge chute is on the machine,
remove it and install the side-discharge deflector;
refer to Removing the Side-Discharge Chute
(page 15).
•
If the grass bag is on the machine, remove it; refer
to Removing the Grass Bag (page
•
If the rear-discharge plug is not installed, grip it by
the handle, raise the rear deflector, and insert it
into the rear-discharge chute until the latch locks
into place; refer to
g033083
1. Rear-discharge plug
Bagging the Clippings
Use the grass bag when you want to collect grass and
leaf clippings from the lawn.
If the side-discharge chute is on the machine,
remove it and install the side-discharge deflector
g012606
before bagging the clippings; refer to
Side-Discharge Chute (page
Installing the Grass Bag
1. Raise and hold up the rear deflector
14
15).
Figure 21.
Figure 21
2. Rear deflector
Installing the
15).
(Figure
g019812
22).