Cleaning And Troubleshooting Your Waterpik - Waterpik WP-250 Mode D'emploi

10

CLEANING AND TROUBLESHOOTING YOUR WATERPIK

Using Mouthwash and
Other Solutions
Your Waterpik Water Flosser can
®
be used to deliver mouthwash and
antibacterial solutions. After using any
special solution, rinse unit to prevent
clogging by partially filling reservoir
with warm water and running unit with
tip pointed into sink until unit is empty.
Cleaning
Before cleaning, unplug from the electrical outlet.
Clean the product when necessary by using a soft
cloth and mild non-abrasive cleanser.
The water reservoir is removable for easy cleaning and
is top rack dishwasher safe.
NOTE: Remove reservoir
valve before placing reservoir
in dishwasher.
Removing Hard Water Deposits
Add 2 tablespoons of white vinegar to a full reservoir
of warm water. Set pressure control dial to high, point
20018513-FAA_250E1_IM_rdF.indd 10
the handle and tip into sink. Turn unit ON (I) and run
until reservoir is empty. Rinse by repeating with a full
reservoir of clean warm water.
Leakage
If leaking due to a damaged hose, replacement hoses
and handles are available from your local distributor
which can be found at www.waterpik.com/intl.
If leakage occurs from the reservoir, ensure
the valve is right side up or contact your
local distributor for a replacement valve.
Service Maintenance
Waterpik
serviceable electrical items and do not require routine
service maintenance. For all your service needs go to
www.waterpik.com/intl to find your local distributor.
Please do not ship product to Waterpik International,
Inc. offices, this will delay service.
Remove Replace
Some replacement parts and accessories for the Water
Flosser are also available from your local distributor
which can be found at www.waterpik.com/intl.
WATER FLOSSER
®
Water Flossers have no consumer-
®
12/10/13 10:16 AM