Waterpik WP-250 Mode D'emploi page 8

8
Prime Unit (First Time Use Only)
Set pressure control dial on base to high, point the
handle and tip into sink. Turn unit ON (I) until water
flows from the tip. Turn unit OFF (O).
O
I
High
2
1
3
Adjusting the Pressure Setting
Turn the pressure control dial on the base of the unit to
the lowest setting (pressure setting No. 1) for first-time
use. Gradually increase pressure over time to the setting
you prefer – or as instructed by your dental professional.
O
I
Low
2
1
3
20018513-FAA_250E1_IM_rdF.indd 8
Recommended Technique
For best results, start with the back teeth and work toward the
front teeth. Glide tip along gumline and
pause briefly between teeth. Continue
until you have cleaned the inside and
outside of both the upper and lower teeth.
Lean over sink. Direct the stream at a
90-degree angle to your gumline with
tip in mouth. Slightly close lips to
avoid splashing but allow water to
flow freely from mouth. Set pressure
at desired setting and turn the unit
ON (I). Begin cleaning.
When
Finished
Turn the unit
OFF (O). Empty
any liquid left in the reservoir. Unplug the unit.
NOTE: If you used a mouthwash or other solution besides
water, see "Using Mouthwash or Other Solutions" section.
O
2
1
3
12/10/13 10:16 AM