Programming Telephones; Lock-Release Code Change - Fermax Duox Manuel D'installation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

DUO
DUO
X DIRECT
X DIRECT
DUO
DUOX DIRECT
DUO
X DIRECT
X DIRECT
DUO
DUO
DUOX DIRECT
X DIRECT
X DIRECT
X DIRECT
DUO
DUO
X DIRECT

Programming Telephones.

1. With the telephone connected, press the programming button (you will hear a beep).
Upon releasing it, you will hear the programmed entrance.
(upon picking up the phone, it automatically activates the panel´s audio and a
conversation may be held with the person on the street panel to indicate the house to
be programmed).
2. Enter the house number via the keypad and press . A programming confirmation is
produced.
* The telephone will not function if it has not been programmed.
For more details see the DUOX cod.97695 telephone instructions and the chapters in this
Section II: "DUOX Amplifier Calling Codes" and "Calling homes from the Direct Panel".
NOTES:
- The DUOX system uses 6 digit house terminal addresses.
- Programming is always done from the panel activated as MASTER.
- Any installation can only have one MASTER panel at a time, whether a single or
multiple block installation, or if configured as a sub-block, block or general entrance.
- Upon programming each phone, it inherits the upper part of the address the street
panel has assigned, if it isn´t a general entrance panel.
- A street panel is configured as a MASTER via the SW1 amplifier button. If the SW1
button is pressed 3 times quickly, it is activated as a MASTER panel and a confirmation
tone sounds (beep-beep). It can also be configured with a keypad code, without
having to open the panel,
The sequence is:
- When a panel is selected as MASTER, it notifies the others of the situation and if
another was previously configured, it would automatically stop being so.
- The panel deactivates itself from the Master mode following the same activation
procedure: 3 quick presses of the SW1 button. A deactivation tone sounds (beep-
bop). It can also be deactivated with a keypad code, without having to open the
panel,
see»Configuring the Direct Panel» for more details.
The sequence is:
- 2 simultaneous conversation channels on the same pair.

Lock-release code change.

You can change the lock-release code from the keypad at anytime (if enabled) without
needing to enter in configuration. It´s useful if you want to allow the residents this change.
The procedure to change it is the following:
A + 3141 + Current code (4 digits) + New Code (4 digits)
If the code is correct, a confirmation tone sounds (beep-beep) and if not the error tone
sounds (beep-bop). In this case you can´t enter a digit with the value "A" as a "New Code».
Pag 52
see»Configuring the Direct Panel» for more details.
Activate the panel as MASTER: 10 (beep) 1
Deactivate the panel as MASTER: 10 (beep) 0
(beep-beep).
(beep-beep).

Publicité

Table des Matières
loading

Table des Matières