Fermax Duox Manuel D'installation page 12

DUO DUO X DIRECT X DIRECT
DUOX DIRECT DUO DUO X DIRECT X DIRECT
DUO DUO DUOX DIRECT X DIRECT X DIRECT X DIRECT
DUO DUO X DIRECT
No es necesario segregar la instalación según ésta jerarquía ya que el sistema se
adapta a las necesidades de la instalación.
NOTA IMPORTANTE:
Programación de parámetros por el instalador.
Para programar - modificar dichos parámetros ver «Seccion II: Manual de Programación»,
(al final de este manual).
EN MASTER Panel:
•
Programming is always done from the panel activated as MASTER.
•
Any installation can only have one MASTER panel at a time, whether a single or
multiple block installation, once configured as a sub-block, block or general entrance.
•
A street panel is configured as a MASTER via the SW1 amplifier button. If the SW1
button is pressed 3 times quickly, it is activated as a MASTER panel and a
confirmation tone sounds (beep-beep). You can also configure it via a code on the
keypad, see Section II.
•
When a panel is selected as MASTER, it notifies the rest of the situation and if
another was previously configured, it would automatically stop being so.
•
If there are various blocks in an installation, we recommend using the general
entrance panel as MASTER since it allows you to program all of its telephones.
•
Once having completed the terminal´s configuration, we recommend deactivating
the MASTER panel to avoid accidentally reprogramming terminals.
•
The panel deactivates itself from master mode following the same activation
procedure: 3 quick presses of the SW1 button. A deactivation tone sounds (beep-
bop). You can also deactivate it via a code on the keypad, see Section II.
Configuration - Programming the Amplifier
The DUOX amplifier can be configured to allow for the operation as a general entrance,
block entrance or sub-block entrance.
•
The DUOX system uses 6 digit house terminal addresses.
•
These call code digits are organised as follows: BBSSNN:
- BB: indicates the Block number, (from 00 to 99).
- SS: indicates the sub-Block number, (from 00 to 99).
- NN: indicates the sub-Block house number, (from 00 to 99).
You do not have to segregate the installation according to this hierarchy since the system
adapts to the installation´s needs.
IMPORTANT NOTE:
Programming the installer´s parameters.
To program or change these parameters see «Section II: Programming Manual», (at the
end of this manual).
Platine MASTER:
F
•
La programmation se fait toujours à partir de la platine activée en tant que
MASTER.
•
Quelle que soit l'installation (un seul bâtiment ou plusieurs), il ne peut y avoir
qu'une seule platine MASTER à la fois, qu'elle soit configurée comme platine
de sous-bâtiment, de bâtiment ou d'entrée générale.
Pag 12