Fermax Duox Manuel D'installation page 47

DUO DUO X DIRECT X DIRECT
DUO DUO DUOX DIRECT X DIRECT X DIRECT
DUO DUO X DIRECT X DIRECT
DUO DUOX DIRECT DUO X DIRECT X DIRECT
Examples:
•
Panel configured as Block
Block 25, range of telephones25XXXX.
•
Panel configured as Block + Sub-block
Block 12 / Sub-block 03, range of telephones 1203XX.
•
Panel configured asGeneral Entrance
General Entrance, range of telephones XXXXXX (000001 to 999999).
Upon making a call,
•
If a Panel is configured as Block it only allows the call to the configured Block (BB).
Block 25, if pressing1
Ιφ α Πανελ ισ χονφιγυρεδ ασ
Block (BB) and Sub-block (SS).
Block 12 / Sub-block03, when pressing
120301.
•
If the Panel is configured asGeneral Entrance
If you press1
Upon making a call, if the selected terminal is in the installation and available (it may be
in conversation with another street panel) it is monitored via a characteristic calling one.
If the marked terminal is not available, a call error tone sounds (beep-bop).
NOTES:
-If a shorter code is entered, it is filled in with "0" to the left.
- Use the 'A' key to delete the entered sequence.
- The '0' entered on the left are considered.
- Once the call to a residence is made, and it is proven to exist and not busy, if you press
the key again a new call is made to the same home. After 30" the last home
marked is not
Opening the door with a code.
You can enable a lock-release code for all residents. This is a 4 digit code and can be
entered by pressing A when the panel is in stand-by and then the 4 digits.
Opening code: A + XXXX
NOTES:
-This option is deactivated by default. To deactivate the opening code you must enter
the value AAAA in position 08, see "Street panel configuration" on the following page.
- If you press the A key before entering the fourth digit of the opening code, the opera-
tion is cancelled. An error tone (beep-bop) indicates that the access code has been
cancelled.
- The open-door relay activation time is the same as when opening from the
+      the following calling code is generated 250001.
Block+Sub-blockit only allows the call to the configured
+      you generate the calling code 000001.
memorised.
+      generates the following calling code
1
home.
Pag 47