Philips AZ 7376 Mode D'emploi page 9

Connections for in-car use
1 Find a safe place for the
CD player on a horizontal,
vibration-free and stable
surface that is not
dangerous or in the way of
the driver or passengers.
2 Connect the DC plug of the
voltage converter to the DC
socket of your CD player
( only for a 12 V car battery, negative grounding ).
3 Insert the voltage converter into the cigarette lighter socket. If necessary, clean the
cigarette lighter socket to obtain a good electrical contact.
4 Turn down the volume and switch off the autoreverse function (if present) of
your car radio cassette player.
5 Connect the adapter cassette plug to the LINE OUT / p socket of the CD player.
6 Slide the adapter cassette carefully into the car radio's cassette compartment.
7 Make sure that the cord does not hinder your driving.
8 Start the CD player, turn its volume to maximum position (10) and adjust the sound
with the car radio controls.
• To remove the adapter cassette press the eject button of the car radio.
• Always remove the voltage converter from the cigarette lighter socket when the CD
player is not in use.
Notes on In-car Use:
- Avoid excessive heat from the car heating or from direct sunlight (e.g., in a parked
car in the summer).
- If your car radio has a LINE IN jack, it is best to use it for the car radio connection
instead of the adapter cassette. Connect the signal lead to this LINE IN jack and
the LINE OUT / p jack of the CD player.
CONNECTIONS
4,5 V DC
9