Entretien; Consignes De Sécurité; Entretien Ordinaire; Routine Maintenance - Barazza FIBFT Série Manuel D'installation Et D'emploi

Table des Matières

Publicité

ENTRETIEN

CONSIGNES DE SÉCURITÉ
Fermer toujours l'interrupteur électrique
principal pendant les opérations d'entretien ordi-
naire ou en cas d'inutilisation prolongée.
Nettoyer à four froid après chaque utilisation:
ceci facilitera l'opération et évitera que d'éventuels
résidus d'aliment ne puissent s'enflammer.
Nettoyer TOUTES les parties de l'appareil uni-
quement selon les modalités et les produits indiqués
dans ce manuel (éviter notamment l'emploi d'éponges
abrasives, racloirs, détergents acides ou agressifs,
appareils à vapeur ou à pression, jets d'eau directs).
Tout nettoyage effectué de manière non conforme
par rapport aux modalités indiquées pourrait mettre
à risque la sécurité des personnes, des biens et des
animaux, et causer des dommages à l'appareil qui ne
seront pas couverts par la garantie.
Toute variation de couleur de la cavité du four
n'en compromet pas les prestations et ne
constitue pas un défaut pour lequel exercer
le droit de garantie.

ENTRETIEN ORDINAIRE

NETTOYAGE

• surfaces en inox et en verre: utiliser un chiffon
doux légèrement imbibé de détergent neutre spé-
cifique : pour les modalités d'emploi des produits
d'entretien, suivre les indications du fabricant.
N'utiliser ni matériel abrasif ni racloir métallique
pointu pour nettoyer les portes en verre du four
car ils pourraient rayer la surface et briser le verre.
• Intérieur du four/grilles des niveaux de cuisson/
grilles/lèchefrites : utiliser un chiffon doux imbibé
de vinaigre tiède, rincer et essuyer soigneusement.
Pour faciliter le nettoyage de l'intérieur du four, il est
possible de :
- retirer les grilles latérales des niveaux de cuisson
(fig.
14): Il est DÉCONSEILLÉ de les laver au lave-
vaisselle pour ne pas compromettre le bon fonc-
tionnement des glissières extractibles;
- baisser la résistance de voûte rabattable en dévis-
sant les deux goujons "A"
- retirer la porte du four
pour la replacer, voir
(fig.
15);
(fig. 16 et 17);
(fig.
18).
MAINTENANCE
SAFETY WARNINGS
Always switch off the main electrical switch
during routine maintenance or if the appliance will
not be used for an extended period.
Clean the oven after each use once it has cooled:
this facilitates the operation and prevents the burning
of food residue.
Clean ALL parts of the appliance using only the
procedures and products indicated in this manual (in
particular, do NOT use abrasive sponges, scrapers, acidic
or aggressive detergents, steam or pressure cleaning
devices, direct jets of water).
Any cleaning performed in a manner different from that
specified may endanger the safety of people, animals
and property as well as cause damage to the appliance
which is not covered by the Guarantee.
A variation in the colouring of the oven cavity
interior does not compromise the oven's perfor-
mance and is not considered a defect covered
by the Guarantee.

ROUTINE MAINTENANCE

CLEANING
• Stainless steel and glass surfaces: use a soft cloth
dampened in neutral detergent: follow the manufactur-
er's instructions on the use of the cleaning products.
Do not use abrasive materials or sharp metal scrapers
that may scratch or crumble the glass.
• Oven interior/cooking level racks/racks/drip trays:
use a soft cloth dampened in warm vinegar, rinse and
dry thoroughly.
To facilitate the cleaning of the oven interior, you can:
- remove the side cooking level racks
them in the washing machine as this may compromise
the correct operation of the pull-out runners;
- lower the drop-down upper heating element by unscrew-
ing the two pins "A"
- remove the oven door
to reposition it, see
26
(fig.
14): do NOT wash
(fig.
15);
(fig. 16 and
17);
(fig.
18).

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Filbt sérieFiwlt série1funpv série

Table des Matières