Declaration Of Conformity; Starting Operation; Working Advice - Bosch GSC 160 Professional Notice Originale

OBJ_BUCH-460-002.book Page 13 Wednesday, April 1, 2009 3:34 PM

Declaration of Conformity

We declare under our sole responsibility that
the product described under "Technical Data"
is in conformity with the following standards
or standardization documents: EN 60745 ac-
cording to the provisions of the directives
2004/108/EC, 98/37/EC (until 28 Dec 2009),
2006/42/EC (from 29 Dec 2009).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Head of Product
Engineering Certification
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Leinfelden, 12.09.2007
Operation

Starting Operation

Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the nameplate of the
machine. Power tools marked with 230 V
can also be operated with 220 V.
Switching On and Off
To start the machine, push the On/Off switch 1
forwards.
To lock the On/Off switch 1, additionally push
down the front of the switch.
To switch off the machine, release the On/Off
switch 1. When the On/Off switch is locked, press
on the rear of the switch and then release it.
Bosch Power Tools

Working Advice

The power tool is not suitable for stationary
operation. For example, it may not be
clamped in a vice or fastened on a workbench.
Only work with the chip deflector 2 mount-
ed. Take care that the chip deflector is not
damaged or bent. Danger of injury when
working without the chip deflector or when it
is damaged. Have a damaged chip deflector
replaced immediately by an after-sales
service centre for Bosch power tools.
Wear protective gloves while working and
pay particular attention to the mains cable.
Take care that cut sheet parts do not bend
toward your body or the mains cable. Sharp
burrs develop at the cut steel sheet and can
cause injuries to the operator or damage the
mains cable. If required, press bending steel
sheet parts away from your body or the
mains cable using gloves.
Apply the power tool to the workpiece only
when switched on.
80–90
˚
Guide the power tool at an angle of 80 to 90° to
the surface of the sheet metal and do not tilt it
to the side.
Guide the machine evenly and with light feed in
the cutting direction. Excessive feed significantly
reduces the service life of the saw blade and can
cause damage to the power tool.
When cutting curves, make sure not to tilt the
power tool laterally and work with low feed rate
only.
1 609 929 M52 | (1.4.09)
English | 13