DeWalt DPW3835 Guide D'utilisation page 18

LatIn aMerIca: This warranty does not apply to products sold in
Latin America. For products sold in Latin America, see country specific
warranty information contained either in the packaging, call the local
company or see website for warranty information.
Free WarnInG LaBeL rePLaceMent: If your warning labels
become illegible or are missing, call 1-877-FNA-GAS1 (1-877-362-
4271) for a free replacement.
Glossary
Bypass mode: Allows water to re-circulate within pump when the gun
trigger is not pulled.
chemical hose: Feeds cleaning agents into the pump to mix with the
water. Refer to chemicals and cleaning solvents.
chemical injection system: Mixes cleaners or cleaning solvents with
water to improve cleaning effectiveness.
choke control: Opens and closes carburetor choke valve.
cu: Cleaning Units. GPM multiplied by psi. (GPM x PSI = CU)
Fuel valve lever: Opens/closes connection between fuel tank and
carburetor.
GPM: Gallons Per Minute. The unit of measure for the flow rate of
water.
PsI: Pounds per Square Inch. The unit of measure for water pressure.
Also used for air pressure, hydraulic pressure, etc.
kPa (kilopascal): Metric pressure measurement. 1 kilopascal equal
1000 pascals.
Quick-connect spray wand: Allows the user to quickly change out
high-pressure nozzles. Refer to Spray Wand Nozzles.
thermal relief valve: When the temperature inside the pump rises
too high the valve will open and release a gush of water in an effort
to lower the temperature inside the pump. The valve will then close.
Water supply: All pressure washers must have a source of water. The
minimum requirements for a water supply are 20 psi (138 kPa) and 5
gallons per minute.
18