Télécharger Imprimer la page

Amann Girrbach artex bn Mode D'emploi page 7

Publicité

Les langues disponibles
  • FR

Les langues disponibles

!
waRnIngS and
Safety aSpectS:
_ how to check the centric adjustment of
artex Bn, cn and artex ct
If the upper part of the articulator has lateral
play, this deviation to the side can be heard
and felt by a „click". In this case, it is neces-
sary to readjust the centric.
Then, please proceed as follows:
_ Close the centric lock.
_ Unscrew the thread pins at the bottom of
the rear part using an allen wrench.
_ Adjust incisal guidance pin centrally in zero
position.
_ Hold the upper articulator part in this position.
At the same time, pull the left semi-axis out-
wardly until reaching the stop, and use the
allen wrench to tighten the thread pin.
Now proceed in the same way with the right
semi-axis.
_ general information
Articulators are precision instruments.
Therefore, it is important to handle them with
care.
Please read the following notes:
_ Periodically check if the axis-joint system and
the condylar paths are clean in order to main-
tain the smooth mobility of the condyle in the
axis and thus maintain the functionality of the
articulator.
_ Remove dirt in this area with a steamcleaner,
then blow dry.
_ Do not place the articulator in a boil-out unit,
a pressure pot or an ultrasonic bath.
_ For cleaning and care, use only cleaning
agents that are suitable for light metals.
U S e R M a n U a l
Regarding the use of the cleaning agent,
please follow the instructions of the according
manufacturer. Do not use cleaning agents
with a pH <5 or >8 since those might damage
the anodized surfaces.
gB
7

Publicité

loading