Publicité
Les langues disponibles
Les langues disponibles
Installation
p When the pan-tilt head is not going to be used any longer, do not leave it in place but
be absolutely sure to dispose of it.
p Tighten up the screws and bolts using the specified torque. If they are tightened using
too much torque, the thread ridges will be damaged, and the pan-tilt head may fall.
Conversely, if they are tightened using too little torque, the screws may come loose.
p Use a torque driver or torque wrench in order to tighten the parts at the specified
torque.
p There are limits on the torque range that can be specified by torque drivers and torque
wrenches. Use the specified torque values that are recommended as a reference, and
use the appropriate torque driver or torque wrench.
p Do not use impact drivers or electrical drivers whose torque is difficult to control since
doing so may damage the screws and bolts.
(Be sure to ask your dealer to install the unit.)
- 23 (E) -
Publicité
