Publicité
Les langues disponibles
Les langues disponibles
Installation
2.
Attaching the tilting arm
Attach the tilting arm to the pan-tilt head using the four tilting arm fixing screws
(M4 C 12 mm) supplied.
p Attach the tilting arm to the pan-tilt head in the direction shown in the figure below.
p Attach the guide pin and camera mounting screws to the camera mounting plate
on the positions as shown in the figure below.
p Tighten up the guide pin using a slot-head screwdriver.
For installation on the ceiling
Tilting arm
Guide pin
Warning
Be absolutely sure to use the fixing screws provided with the unit.
Use of any other screws may cause the tilting arm to fall out of position or a load to be applied
to the rotation operation in the tilting direction, possibly causing trouble or triggering the
establishment of one of the safe modes.
Tighten the fixing screws using the clamping torque below, and check that there is no play in the
tilting arm.
(Be sure to ask your dealer to install the unit.)
Tilting arm fixing
screws
Camera
mounting plate
Guide
screws
Camera mounting
screws
Attaching the plate and arm
p Tilting arm fixing screws
p Guide screws
For stand-alone installation
Camera mounting
screws
Clamping torque
1.5 N
- 19 (E) -
Guide pin
m (15 kgf
cm)
•
•
Publicité
