Computer Connection; Battery Charge - INFOSEC UPS SYSTEM E4 700 Mode D'emploi

The wiring configuration is shown as the following procedure:
1. Remove the small cover of the terminal block
2. Use AWG14 or 2.5mm2 wires for wiring configuration
3. Connect cables to the terminal block and make sure to respect Line and Neutral positions.
4. Put the rear panel protection cover back.
5.3

Computer Connection

Connect your computer to the outlet of the UPS system following the above diagram.
CAUTION - Do not connect equipment which would overload the UPS system (e.g. laser
printers).
5.4

Battery Charge

To fully charge the batteries of the UPS system leave the UPS system connected to the mains for 8 hours.
You may use the UPS system directly without charging batteries but the stored energy time may be shorter
than the nominal value.
INFOSEC UPS SYSTEM - 4, rue de la Rigotière – 44700 Orvault – FRANCE - www.infosec.fr
Hot Line : tel : + 33 (0)2 40 76 15 82 - fax : + 33 (0)2 40 94 29 51 - hotline@infosec.fr - 07 05 04 205 04
4
Schema 1: E 2000S/3000/3000S connection diagram
５３