Connection And Operation: E 700/1000(S)/2000(S)/3000(S); Control; Wiring - INFOSEC UPS SYSTEM E4 700 Mode D'emploi

5 Connection and Operation: E
The system has to be installed and wired only by qualified electricians in accordance with
safety regulations!
6. When installing the electrical wiring, please note the nominal amperage of your incoming
5.1

Control

Inspection: when you receive your equipment, check out the packaging carton and its contents to make
sure there is no damage. Please inform immediately the carrier if you should find signs of damage.
Please keep the packaging in a safe place for future use.
Note: Please make sure the incoming feeder is isolated and secured to prevent it from being
switched back on again.
5.2

Wiring

5.2.1 UPS Input Connection
If the UPS is connected via the power cord, please use a proper outlet with protection against electric
power cuts and pay attention to the capacity of the outlet: over 10A for E
4
E 2000(S) & 3000(S).
5.2.2 UPS Output Connection
4
The output of E 1000(S) and 2000(S) are IEC female type outlets (4 and 6). Plug the load power cord to
the output outlets to complete connection.
Model No.
700
1000/1000S
2000
2000S
3000/3000S
Besides output outlets, E
output as well.
５２
Hot Line:
Output Outlets
4
4
6
4
4
4 4
2000S and E 3000/3000S are equipped with a terminal block available for
INFOSEC UPS SYSTEM - 4, rue de la Rigotière – 44700 Orvault – FRANCE - www.infosec.fr
tel : + 33 (0)2 40 76 15 82 - fax : + 33 (0)2 40 94 29 51 - hotline@infosec.fr - 09 05 04 205 12
4
700/1000(S)/2000(S)/3000(S)
feeder.
4
1000(S) & 2000 and over 16A for
Terminal Block
Nil
Nil
Nil
Yes
Yes