Publicité
Les langues disponibles
Les langues disponibles
ULTRAFLEX
3.7 Electrical connections
WARNING
ULTRAFLEX is not to be held responsible for possible damages or malfunctions deriving from operation not
workmanlike performed.
DANGER
Do not bend the electrical cables near the power unit fairleads: the system explosion-proof safety would no
longer be ensured.
NOTICE
Even though the communication cable is made up of quality materials, install it in a dry and sheltered
place, far from saline mist, splashes, etc. Do not install it on external parts.
3.7.1 Power cable
The power cable supplied by ULTRAFLEX is a high quality salt water and oil resistant cable.
To ensure a correct operation, the power cable cannot be tampered with. It is forbidden to change the cable
length, the fuse or its container and the indications below must be strictly followed. It is only possible to replace
the eyelet connectors supplied as cable ends; in this case, it is necessary to keep the contact protective covers
supplied with the cable or replace them with other ones which can properly cover the electrical contacts.
Find the wiring diagram below:
Colour
Use
Red
Positive wire
Black
Ground wire
To make cable passage easier, the fuse holder has been disconnected from the power cable.
In order to connect the fuse holder, after laying the cable, do as follows:
Remove the transparent cover of the fuse holder
and the fuse.
Put the seal on the conductor until it adheres to the
fuse holder checking that it has been inserted properly.
WARNING
Make sure the fuse holder seal has been inserted properly to prevent water penetration.
page 32
of 143-
POWER ASSISTED STEERING SYSTEM
Installation, Maintenance and Owner's Manual
Insert the faston into the free space of the fuse
holder.
Place the fuse in the fuse holder and put the
proper transparent cover.
Publicité
