Publicité
Les langues disponibles
Les langues disponibles
ULTRAFLEX
7
Put seal (10) on the hub paying great attention
not to damage it, especially when making it
pass through the the milled profile of the key.
NOTICE: Make sure hole (11) is positioned
downwards so that condensation
can be drained.
Put cover (12) and fix it by means of the four
screws (13) with a maximum torque of 8 Nm
(5,9 lb ft).
NOTICE: Make sure the seal is properly fixed
inside its seat.
8
Position the steering wheel supplied
separately (14) on the helm shaft (15) by using
the suitable key (16). Insert washer (17) and
tighten the self-locking nut (18) with a 15/16"
open end wrench and with a torque of 40
Nm (29,5 lb ft); then grease the thread by
using some anti-seize grease MOLYKOTE
1000 or a similar one.
CAUTION
If the self-locking nut (18) is disassembled, it must
be replaced. (Contact our Technical Assistance
Service, see page 7).
Installation, Maintenance and Owner's Manual
12
13
10
®
17
18
POWER ASSISTED STEERING SYSTEM
11
14
page 25
-
16
15
of 143
Publicité
