Technical Specifications - Fracarro SIG7720 Instructions D'emploi

The following message is
e
displayed within the INPUT
menu: "Communication with
the receiver not available
now ... try again in a few
minutes."
The parameters
streamer and/or the input of
the coupled receiver cannot
be modified
IP output connector and programming
Max bit rate
Level
Max. number of modules that can be connect
in loop-through
Output
MPEG information
WEB Services
Supported transmission protocols
Programming
Power supply tension
Max consumption
Operational temperature
Dimensions
Technical data is nominal values and refer to an operating temperature of 25° C
The coupled receiver is not ac-
cessible at the moment
of the
Streamer not accessible at the
moment

9. TECHNICAL SPECIFICATIONS

CONNECTORS
INPUT SIGNALS
OUTPUT SIGNAL
GENERAL
1. Wait for a few seconds;
2. Reboot the SIG7720 streamer;
3. Make sure that the TS OUTPUT
is enabled within the OUTPUT-TS
OUTPUT menu of the coupled re-
ceiver;
4. Update the firmware of the cou-
pled receiver;
Reboot the SIG7720 streamer;
Suggestion: program an SIG7720
module per time
1 RJ45 connector
100Mbit/s
10pc (in a single SIG7901)
Up to 12 digital encoded program in IP with single
multicast address
Available MPEG2 information
DVB Encapsulation, HTTP, TELNET, FTP, SAP
ETSI TS102034 v.1.1.1 MPEG2TS over UDP or
MPEG2TS over RTP/UDP complian. PAT, PMT,
SDT recovered tables.
TPE e PC
220-240V ~ 50-60 Hz
-5 to +45°C
35 x 130 x 240mm
43
TTL
4W