Fracarro SIG7720 Instructions D'emploi page 36

6. Enter the INPUT menu to configure the parameters of the receiver coupled to the SIG7720 module.
In the event of a satellite receiver, set the transponder's IF frequency and select the polarity (VL / HL
/ VH / HH), the DiSEqC and the Symbol Rate. In the event of a digital terrestrial receiver, set the fre-
quency/channel of the digital terrestrial MUX. Enter the Program List menu to select the channels you
want to stream.
If the SIG7720 streamer you are programming is not joined (on its left) by a receiver (loop-through ena-
bled), it will not be possible to program the input parameters of the receiver from the INPUT menu; only
the coupling conditions of the Transport Stream will be visible.
Username --> admin
Password --> fracarro
36
In this case, within the INPUT menu,
it is possible to check whether the
Transport Stream is coupled correct-
ly; if necessary, send the Transport
Stream to other adjacent modules
(if any) (to modify the settings for
the first time, it is necessary for
the user to carry out the authenti-
cation by entering by default).
F
L
L
A
L
t
7
A
F
M
M
p
M
R
c
E
W
2
t