Fracarro SIG7720 Instructions D'emploi page 33

>
HEADEND
SETUP
Select the language
TPE SETUP
Select the
communication rate of
the 485 port
Select the
communication rate of
the 232 port (not active)
TPE waiting time for the
answer of the controls sent
to the headend (timeout
value must be 30)
Regulation of the TPE
display contrast
Restore the TPE default
settings
confirm the settings by pressing the
pressing the S key after the modules programmation
5.2.9 HEADEND SETUP AND KTP EMULATION MENU
Navigation in the headend
programming menus
NAVIGATION
(not available) NAVIGATION OSD
Automatic
acknowledgement of the
HEADEND SCAN
headend connected to
the TPE
Export the headend
COPY
configuration to another one
Restore the module
FACTORY SETUP
defaults setting
SET ADDRESS
Restart the module
RESET MODULE
Emulation of the KTP
programmer
KTP
EMULATION
confirm the settings by pressing the
pressing the S key after the modules programmation
5.2.8 TPE SETUP MENU
LANGUAGE
BAUD RATE 485
BAUD RATE 232
TIMEOUT COM
CONTRAST LCD
RESET?
key; save the settings by
SIG7720
Module search....
SIG7720
Address not valid
SIG7720
KTP
EMULATION
key; save the settings by
33
Italian English
9600 115200
9600 115200
Increase/decrease from TPE by
using the arrow keys, or enter
1 30
the value directly from the
keyboard.
Increase/decrease fromTPE by
using the arrow keys or enter
0 31
the value directly from the
keyboard.
YES=V NO=X
Refer to the SIG7720 general
programming menu
Automatic search of the
headend or the connected
device. After searching, the
main menu can be seen from
the NAVIGATION function
All
Yes=V
modules
Read-only
All
Yes=V
modules
The function is not
available for the
V=OUTPUT
programming of the
SIG7720 module
English
Italiano
Deutsch
Français
Espanol
Portuguese
9600
19200
38400
57600
115200
9600
19200
38400
57600
115200
NO=X
NO=X