Measurement Menu - Fracarro SIG7720 Instructions D'emploi

WARNING: the IP addresses selected for multicasting must be chosen within the 224.0.1.1 -->
239.255.255.255 range.
MULTICAST
OUTPUT
GROUP
confirm the settings by pressing the
MEASURES
Total Bit Rate
confirm the settings by pressing the
5.2.6 OUTPUT MENU
Refer to the same
programming menus shown for
GROUP 1 setting
(The maximum MULTICAST
GROUP available are 12)
GROUP 1
Enter by
MULTICAST IP reading
MULTICAST
IP
MULTICAST PORT reading
MULTICAST
PORT
RTP LAYER
ENABLE GROUP

5.2.7 MEASUREMENT MENU

pressing the S key after the modules programmation
SOFTWARE VERS.
TOTAL Kbps
pressing the S key after the modules programmation
32
GROUP 12
MULTICAST IP
__.xxx.xxx.xxx
xxx.xxx.xxx.xxx
xxx.__.xxx.xxx
Exit by
xxx.xxx.__.xxx
xxx.xxx.xxx.__
MULTICAST PORT
1024
xxxx
ON OFF
ON OFF
key; save the settings by
SIG7720 vers. 00
20000Kbps
key; save the settings by
Increase/decrease by
using the TPE arrow
keys or enter the value
directly from the
keyboard.
__.xxx.xxx.xxx
value
xxx.__.xxx.xxx
value
xxx.xxx.__.xxx
value
xxx.xxx.xxx.__
value
65535
Increase/decrease by
using the TPE arrow
keys or enter the value
directly from the
keyboard.
Read-only
Read-only