Technical Specifications; Module Programming; General Menu - Fracarro HEAD LINE SIG7900 Instructions D'emploi

Module d' interconnexion

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Mains power

Power consumption

Operating temperature

Back panel connections

It is now possible to program all the HEADLINE modules from one point.

Connect the TPE programmer to the 1st interconnection module using the RJ45IN socket (if there

are more rows the RJ45OUT socket should be used by the PATCH-RJ45 cable).

Wait a few seconds for the TPE to search for all connected devices and create a map of the hea-

dend. The display will show information regarding devices found.

Once the search has been completed the Fracarro logo will be displayed. By pressing any button

(except X) you will enter the programming menu.

Each module is uniquely identified by two numbers, the first is the row number and the second

is the position number within the row. The row number is given by the interconnection module

(shown on the display) while the position number is identified by the label (see the chapter "iden-

tification of the module").

The diagram below shows the programming menu of the HEADLINE headend.

Refer to the operating instructions for each module to obtain information regarding their opera-

tion.

Fracarro