Télécharger Imprimer la page

AirSep FreeStyle 5 Manuel Du Patient page 238

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
EN
Recommended separation distances between portable and mobile RF
The FreeStyle 5 is intended for use in an electromagnetic environment in which radiated RF
disturbances are controlled. The customer or the user of the FreeStyle 5 can help prevent
electromagnetic interference by maintaining a minimum distance between portable and mobile RF
communications equipment (transmitters) and the FreeStyle 5 as recommended below, according to
the maximum output power of the communications equipment.
Rated
maximum
output power
of transmitter
W
0.01
0.1
1
10
100
For transmitters rated at a maximum output power not listed above, the recommended separation
distance d in metres (m) can be estimated using the equation applicable to the frequency of the
transmitter, where P is the maximum output power rating of the transmitter in Watts (W) according to
the transmitter manufacturer.
NOTE 1 At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by
absorption and reflection from structures, objects and people.
Guidance and manufacturer's declaration - electromagnetic emissions
The FreeStyle 5 is intended for use in the electromagnetic environment specified below. The customer
or the user of the FreeStyle 5 should assure that it is used in such an environment.
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
EN-42
communications equipment and the FreeStyle 5
Separation distance according to frequency of transmitter
from 150kHz to 80MHz
d= 1.2 x √P
0.12
0.38
1.2
3.8
12
Compliance
Group 1
Class B
Class A
Complies
(m)
from 80MHz to 800MHz
d= 1.2 x √P
0.12
0.38
1.2
3.8
12
Electromagnetic Environment guidance
The FreeStyle 5 uses RF energy only for its internal
function. Therefore, its RF emissions are very low and
are not likely to cause any interference in nearby
electronic equipment.
The Freestyle 5 is suitable for use in all establishments,
including domestic establishments and those directly
connected to the public low-voltage power supply
network that supplies buildings used for domestic
purposes.
FreeStyle 5™
from 800MHz to 2.5GHz
d= 2.3 x √P
0.23
0.73
2.3
7.3
23
®
AirSep
Corporation
MN167-1 rev. – 02/13

Publicité

loading