ABB TTF300 Note De Mise En Exploitation page 40

Safety
1 Safety
1.1 General information and notes for the reader
Read these instructions carefully prior to installing and commissioning the device.
These instructions are an important part of the product and must be kept for later use.
These instructions are intended as an overview and do not contain detailed information on all
designs for this product or every possible aspect of installation, operation and maintenance.
For additional information or in case specific problems occur that are not discussed in these
instructions, contact the manufacturer.
The content of these instructions is neither part of any previous or existing agreement, promise
or legal relationship nor is it intended to change the same.
This product is built based on state-of-the-art technology and is operationally safe. It has been
tested and left the factory in a safe, maintenance-free state. The information in the manual must
be observed and followed in order to maintain this state throughout the period of operation.
Modifications and repairs to the product may only be performed if expressly permitted by these
instructions.
Only by observing all of the safety information and all safety/warning symbols in these
instructions can optimum protection of both personnel and the environment, as well as safe and
fault-free operation of the device, be ensured.
Information and symbols directly on the product must be observed. They may not be removed
and must be fully legible at all times.
1.2 Intended use
To measure the temperature of fluid, pulpy or pasty substances and gases or resistance/voltage
values.
The device is designed for use exclusively within the stated values on the name plate and in the
technical specifications (see the "Specifications" chapter in the operating instructions or on the
data sheet).
• The maximum operating temperature must not be exceeded.
• The permitted operating temperature must not be exceeded.
• The housing protection type must be observed.
4 - EN TTF300 CI/TTF300-X1