Commissioning And Operation - Kübler MWE02 Instructions D'utilisation

Recommended pre-
load 5 N, approx.
6.5 mm spring travel
Spring travel work-
ing range ±4 mm
4.1.6 Changing the fastening possibilities
Mounting the encoder:
a) Make sure on which side the encoder is to be mounted
(Step 7 [} 5]).
b) The encoder can be mounted in 30° steps, paying atten-
tion to the encoder cable outlet (Step 8 [} 5]).
c) At the desired position, tighten the three M3 screws with a
torque of 1 Nm (Step 9 [} 6]).
Mounting the measuring wheel:
a) Place the measuring wheel on the encoder shaft and push
it entirely towards the encoder until the stop (Step 10
[} 6]).
b) The set screw must be placed on the flat of the shaft.
Tighten it with a torque of 1 Nm (Step 10 [} 6]).
BA MWE02 - R60089.0009 - 01

5 Commissioning and Operation

Maximum spring
travel
Pressure force
Risk of injury due to rotating shafts
related to the
spring travel
Hair and loose clothing can be caught by rotating shafts.
• Prior to any work, proceed as follows:
ð Switch the operating voltage off and stop the drive shaft.
ð If this is not possible, the shafts must be covered.
6 Maintenance
In harsh environments, we recommend regular inspections
for firm seating and possible damages at the device. Repair
or maintenance work requiring opening the device may only
be performed by the manufacturer.
In the event of questions or spare parts deliveries, please
provide us the data printed on the type plate of the device.
See chapter Contact [} 25].
Prior to the work
• Switch off the power supply and secure it against switching
on again.
• Then disconnect the power supply lines physically.
• Remove operating and auxiliary materials and remaining
processing materials from the measuring system.
DANGER
EN - 23