Publicité
Les langues disponibles
Les langues disponibles
KRT-01-4P
DIGITAL EARTH RESISTANCE TESTER
an ELCB is used.
* Follow the proper connection such as Fig1.
VII. DC/AC VOLTAGE MEASUREMENTS
1, Set the function switch to the highest 1000V DC (
) or
750VAV (~) position.
2, Insert the black test lead banana plug into the negative COM
jack.
3, Insert the red test lead banana plug into the positive V jack.
4,Touch the black test probe tip to the negative side of the circuit.
5,Touch the red test probe tip to the positive side of the circuit.
6,Read the voltage in the display.
DC/AC VOLTAGE MEASUREMENTS: If the polarity is
reversed, the display will show (-) minus before the value
VIII. 200k R ESISTANCE MEASUREMENTS
1, Set the function switch to the highest 200k position.
2, Insert the black test lead banana plug into the negative COM
jack
3, Insert the red test lead banana plug into the positive jack.
4, Touch the test probe tips across the circuit or part under test. It
is best to disconnect one side of the part under test so the rest of
the circuit will not interfere with the resistance reading.
5, Read the resistance in the display
www.grupotemper.com
9
Publicité
