Wear And Storage; Manufacturers And Distributors; Dealers And Addresses - SQlab Ergolux Mode D'emploi

The originally purchased product automatically becomes the property of SQlab GmbH. SQlab will contact you after a thorough check for
a suitable replacement product.
Claims under the end customer guarantee exist only if:
• The SQlab product has been registered in the SQlab Crash Replacement Programme
(can be found on our website www.sq-lab.com in the service area under crash replacement)
• The purchase can be proven by receipt.
• No changes have been made to the product.
• The intended use has been observed.
• The defect of the saddle is not due to improper installation or lack of maintenance.
• Excluded is damage due to wear.
• The supplementary end customer guarantee applies only in Germany
There are no further claims on the part of the end customer towards SQlab GmbH under this guarantee.
In the event of a defect or a warranty request, SQlab GmbH is the contact person.

Wear and storage

Bicycles and their components are subject to function-related, mostly usage-dependent wear, such as the abrasion of tyres, grips and
brake pads. Environmental wear results from storage under aggressive environmental conditions, such as solar radiation and the influ-
ence of rain, wind and sand.
Wear is not covered by the warranty.
Note
Note
Store your SQlab ERGOLUX
conditions:
• Away from direct sunlight.
• Storage at temperatures between -10 ° C and 40 ° C.
• Humidity below 60%.

Manufacturers and distributors

SQlab GmbH, Postweg 4, 82024 Taufkirchen, Germany
Foreign distributors, dealers and addresses
A list of our national and international distributors and dealers can be found on our website:
http://www.sq-lab.com
saddle (mounted or unmounted) under the following
®