SilverCrest SSW 400 A1 Mode D'emploi page 31

Fitting/removing the attachments
WARNING! RISK OF INJURY!
► Do not insert the plug into the mains power socket until the appliance is
fully assembled.
► Take great care when handling the attachments
very sharp!
1) To fit an attachment
the attachment
The two bulges on the drive shaft
shaft of the attachment
2) Then push the attachment firmly onto the drive shaft
NOTE
► The beating disc
facturing error, but designed to whip air into liquids.
■ 28 │ GB │ IE
onto the drive shaft
onto the drive shaft
until you hear and feel it click into place.
is fitted onto the shaft at an angle. This is not a manu-
, push the shaft of
on the blender foot
should grip into the recesses on the
:
so that the attachment
! They are
.
SSW 400 A1