Motorola CLP Serie Guide De L'utilisateur page 21

4 To receive calls, listen through the earpiece and press the PTT button to respond.
2.6.1
Talk Range
Table 2: Talk Range
Application
Unit to Unit
With Repeater
2.7
Menu Setting
Procedure:
1 To navigate through the menu settings, press the Menu button.
2 To exit the menu, short press the PTT button or wait for three seconds.
2.7.1
Operations Using Menu Settings
This section explains operations using the menu settings.
NOTE:
It is not necessary to wait for the voice prompt to be completed before continuing with pressing
the next button.
If you are in the menu mode, short press PTT or wait 3 seconds to exit the menu.
Procedure:
1 Changing channel:
a Press Menu button to navigate to Channel.
b Press the (+) or the (-) button to change channel.
2 Entering Monitor Mode:
a Press Menu button to navigate to Monitor.
b Press the (+) to activate or the (-) button to deactivate monitor.
3 Entering Scan Mode:
a Press Menu button to navigate to Scan.
b Press the (+) to activate or the (-) button to deactivate scan.
4 Enabled through Customer Programming Software (CPS):
Sending Call Tone:
a Press Menu button to navigate to Call Tone.
b Press the (+) or the (-) button to send call tone.
5 Enabled through Customer Programming Software (CPS):
Long Press Menu button for 2s to access:
a Easy Access Call Tone.
Industrial (Inside steel/con-
crete industrial buildings)
2
Up to 100,000 ft (9,200 m
2
Up to 250,000 ft (23,200 m
MN006179A01-AD
Chapter 2 : Getting Started
Multi-Level (Inside multi-lev-
el buildings)
2
) Up to 10 floors
2
) Up to 20 floors
21