Scheppach AB1600 Traduction Des Instructions D'origine page 42

Appliance-Specific
tions for Hammers
• Wear ear protectors. Exposure to noise
can cause hearing loss.
• Use auxiliary handle(s), if supplied with
the tool. Loss of control can cause per-
sonal injury.
• Hold power tool by insulated gripping
surfaces, when performing an opera-
tion where the cutting accessory may
contact hidden wiring or its own cord.
Cutting accessory contacting a "live"
wire may make exposed metal parts of
the power tool "live" and could give the
operator an electric shock.
• Use suitable detectors to determine if
utility lines are hidden in the work area
or call the local utility company for as-
sistance. Contact with electric lines
can lead to fire and electric shock.
Damaging a gas line can lead to ex-
plosion. Penetrating a water line caus-
es property damage or may cause an
electric shock.
• When working with the machine, always
hold it firmly with both hands and pro-
vide for a secure stance. The power tool
is guided more secure with both hands.
• Secure the workpiece. A workpiece
clamped with clamping devices or in a
vice is held more secure than by hand.
• Wear a dust mask.
42 | GB
Safety Instruc-
www.scheppach.com
Additional Safety and Working In-
structions
WARNING ≥ 16 kg
• Do not overreach. Keep proper footing
and balance at all times.
• Use protective equipment. Always wear
safety glasses when working with the
machine. The use of protective clothing
is recommended, such as dust mask,
protective gloves, sturdy non-slip foot-
wear and ear defenders.
• The dust produced when using this
tool may be harmful to health. Do not
inhale the dust. Use a dust absorption
system and wear a suitable dust pro-
tection mask. Remove deposited dust
thoroughly, e.g. with a vacuum cleaner.
• Always keep the connection cable from
the working area of the device. Always
guide the cable backwards, away from
the device!
• Do not machine any materials that pres-
ent a danger to health (e.g. asbestos).
• When working in walls ceiling, or floor,
take care to avoid electric cables and
gas or waterpipes.
• Please turn the device immediately off
when the tool used gets blocked! Do
not turn the device on again when the
tool is still blocked. This could cause
bounce back with a high reaction mo-
ment. Determine and remove the cause
of the blocking of the tool used while re-
specting the safety instructions.
• The possible causes may be:
- it is tilted in the workpiece to be ma-
chined
- it has pierced through the material to
be machined
- the power tool is overloaded