Denon AVR-2106 Mode D'emploi page 12

ENGLISH
Easy Setup and Operation
Starting Auto Setup
1
SETUP
Press the button.
• The "System Setup" menu appears.
2
D D
CURSOR
Press the or
"Auto Setup", then press the
• The "Auto Setup" screen appears.
3
CURSOR D D
Press the or
"Power Amp Assign", then press the
G G
or button to select "S. Back" or "Bi-Amp".
When "S. Back" is selected, the test tone during Auto
Setup will be output from the Surround back speaker.
When "Bi-Amp" is selected, change the setting to "Bi-
Amp". The test tone during Auto Setup is set so that it will
be output from the Bi-Amp speaker.
4
Press the
"Start", then press the
• Start the measurements.
Measurement of each channel is performed as follows:
1
H H
button to select
FL FR
ENTER
button.
1: Only the front speakers (A) are measured, front
speakers (B) are not available. Even if the front
speakers (B) are set, the setting automatically
switches
measurements are completed.
2: The subwoofer speaker is measured twice.
3: When "Bi-Amp" is selected, these are not displayed.
After each channel is measured, "Calculating"
appears.
The display switches to the Auto Setup check screen
automatically.
H H
button to select
CURSOR F F
CURSOR D D H H
or button to select
CURSOR F F
button.
2 3
C SW SL SR SBL SBR
to the front speakers (A) once
9
ENGLISH
Easy Setup and Operation
• Measurement is canceled if the MASTER VOLUME control knob
is operated while the Auto Setup is performed.
• If the output volume and crossover frequency of your
subwoofer speaker can be changed, then set the volume to
halfway and the crossover filter to maximum or switch off
the low-pass filter.
2 About automatic retry
To confirm the results of the measurements, remeasurement is
automatically performed.
Remeasurement is performed up to 2 times. During this time,
"Retry1" or "Retry2" is displayed on the screen.
NOTE:
• When measurements have been made using the
measurement microphone, speakers with built-in filters,
such as a subwoofer, might be set to a value that differs
from the physical distance because of the internal electrical
delay.