Denon Professional DN-V750 Mode D'emploi page 30

ENGLISH
2 List of script commands
("n" refers to an integer)
Command
1 comment
2 play
3 play standby
4 play start
5 end
6 pause
7 still
8 stop
9 audio control
10 video control
11 goto
12 set time code
13 wait
14 on key go
15 on SMPTE-tc goto
16 if day of week goto
17 on rtc goto
18 on break goto
19 osd display
20 osd print
21 osd attribute
22 osd clear
23 tc interrupt control
24 rtc interrupt control
25 com-port set
26 com-port put
27 com-port hex put
28 parallel out set
29 site command enable
30 SNTP time calibration
31 still mode set
32 variable set
33 loop
34 write log
"@" in the "@" column indicates commands for which "@" can be used.
30
@ Format
; Comment
Playback of 1 or 2 files. The script does not move to the next step unless the file is
PLAY
played to the file end.
PLAYRDY Preparation for file playback
PLAYGO Start playback of file for which the play standby mode is set from the specified TC
END End/change script file execution
PAUSE Set pause mode (screen blacked out)
STILL Set pause mode (still picture displayed on screen)
STOP Stop playback (still picture displayed on screen)
@ AUDIO Switch audio output on and off
@ VIDEO Switch video output on and off
GOTO Forced change of command sequence
@ SETTC Set self-running time code
WAIT Wait specified number of seconds or until specified time code
@ ONKEYGO Set a forced change of command sequence at the time of key input
@ ONSMPTCGO Time code interruption
@ IFDWKGO Change command sequence according to day of week
@ ONRTCGO Real time timer interruption
@ ONBREAK Specify new processing position when an execution break command is received
@ OSDDISP Switch user OSD display on and off
@ OSDPRT Write 1 line of user OSD
@ OSDATT Set user OSD attribute
@ OSDCLR Clear line(s) of user OSD
@ TCINT Disable/enable time code interruption
@ RTCINT Disable/enable RTC interruption
@ COMSET Serial port communications mode setting
@ COMPUT Output 1 line from serial port
@ COMHXPUT Output binary data to serial port
@ OUTPORT Parallel remote output terminal setting
@ SITECMD Enable acceptance of site command
TIMECAL Time calibration by SNTP protocol
@ STLMODE Set screen display in still mode
@ SET Set loop counter value
LOOP Loop according to loop counter and label
WRITELOG Output operating log file
Description