Sanitising The Water Circuit - Jacuzzi Opalia Serie Utilisation Et Entretien

Sanitising the water circuit

Operate the adjustment knobs
on the face plate (A) to shut off
the air: this will prevent forming
foam while the pump is running.
Also check that all the hydro-
massage nozzles are open.
If you wish to sanitise the water circuit of the tub (recommended frequency: approximately
once a month), we recommend to use J-MX 07 disinfectant, purchasable from Jacuzzi® Ser-
vice Centres and Authorised Retailers.
For sanitization, you can use the same water used for hydromassage so long as no soaps,
oils, or cosmetic products have been used. Otherwise, you can use "fresh" water (that is, by
emptying the tub and filling it again). In both cases, the water level, without anybody in the
water, must completely cover the highest hydromassage nozzles.
To perform a sanitisation cycle, just pour 50 - 150 ml of J-MX 07 disinfectant liquid into
the water (according to the amount of water in the spa) and operate the hydromassage
for about one minute. Then allow the disinfectant to act for about 15 minutes more. Fi-
nally, empty the tub.
37