Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
"Classic"
hydromassage
instructions
General features
air-water mixture adjustment
knobs (where included) (A)
hydromassage cycle on/off button (B)
hydromassage cycle LED (C)
All the buttons installed on the
tub rim are powered at very
low voltage for total safety.
Starting the hydromassage
The hydromassage and suction
nozzles of the tub will remain closed
when the hydromassage is off; press
the button (B) to start the pump
and immediately open the suction
nozzle. The hydromassage nozzles
will open after a few seconds.
The tub is provided with an electronic
sensor which prevents the pump from
starting if the water level is lower than
the minimum. Therefore, if the pump
does not start when the button (B)
pressed and you hear a long beep,
add water and press the button again.
The pump will also stops if the water
level drops suddenly, e.g. when
you step out of the tub. In all cases,
the hydromassage can be started
again by pressing the start button
after solving the problem (power
blackout, low water level, etc.).
T
he hydromassage is activated by means of the buttons on the face plate, where the
air-water nozzle mixing knobs are also arranged. A LED is present near the electronic but-
ton which lights up when the pump is on.
C
B
Trip the master switch to turn the tub on.
To enjoy a Jacuzzi® hydromassage, simply get into the tub and press the start button
(B).
When in the tub, the water level must completely cover the highest nozzles.
The hydromassage is programmed to last for approximately 20 minutes; the cycle will
automatically stop after this time.
Press the start button (B) to stop the cycle before.
Refer to the general instructions for use for how to adjust the air-water mixture or the
intensity of the nozzles.
36
A
C
B
A
C
B
JACUZZI
®
by
Publicité
Table des Matières
