Télécharger Imprimer la page

MaxxGarden 21012 Mode D'emploi page 79

Publicité

STEP 4
STEG 4
4-1. Ta bort de fyra skruvarna från brännaren.
4-1. Remove the 4 bolts from the burner.
STEP 4
4-2. För in gasslangen genom stolpen.
4-2. Put the gas hose through into the post.
4-3. Fäst brännarenheten till stolpen med de fyra bultarna.
4-1. Remove the 4 bolts from the burner.
4-3. Fix the burner unit to the post by the 4 bolts.
4-2. Put the gas hose through into the post.
4-3. Fix the burner unit to the post by the 4 bolts.
STEG 5
STEP 5
5-1. Kontrollera att den vertikala stolpen och brännaranslutningen
5-1. Check whether the connection of vertical post and burner are
STEP 5
är monterad enligt instruktionerna och att alla muttrar och
bultar är åtdragna.
assembled according to instructions, and all bolts and nuts are
5-1. Check whether the connection of vertical post and burner are
5-2. Placera 3 stycken stora platta brickor på tre reflektoravstånd.
tightened.
assembled according to instructions, and all bolts and nuts are
5-2. Put 3 pcs Large Flat Washers on 3
tightened.
5-2. Put 3 pcs Large Flat Washers on 3
STEP 6
STEG 6
STEP 6
Fasten the reflector with 3 pcs Large Flat Washers and 3 pcs Wing Nuts.
Fäst reflektorn med 3 stycken stora platta brickor
Fasten the reflector with 3 pcs Large Flat Washers and 3 pcs Wing Nuts.
och 3 stycken vingmuttrar..
Reflector Spacers.
Reflector Spacers.
- 8 -
- 8 -
STEG 4
STEP 4
STEP 4
Bult
Bolt
Bolt
STEG 5
STEP 5
STEP 5
Reflektor
Reflector Spacer
avstånd buske
Reflector Spacer
STEG 6
STEP 6
STEP 6
Vingmutter
Wing nut
Wing nut
Reflektor
Reflector
Reflector
79

Publicité

loading