Télécharger Imprimer la page

MaxxGarden 21012 Mode D'emploi page 49

Publicité

STEP 4
PASO 4
4-1. Retire los 4 tornillos del quemador.
4-1. Remove the 4 bolts from the burner.
STEP 4
4-2. Inserte la manguera de gas a través del poste.
4-2. Put the gas hose through into the post.
4-3. Fije la unidad del quemador al poste con los 4 pernos.
4-1. Remove the 4 bolts from the burner.
4-3. Fix the burner unit to the post by the 4 bolts.
4-2. Put the gas hose through into the post.
4-3. Fix the burner unit to the post by the 4 bolts.
PASO 5
5-1. Verifique que el poste vertical y la conexión del quemador
STEP 5
estén ensamblados de acuerdo con las instrucciones y que
5-1. Check whether the connection of vertical post and burner are
STEP 5
todas las tuercas y pernos estén apretados.
5-2. Coloque 3 piezas de arandelas planas grandes en
assembled according to instructions, and all bolts and nuts are
5-1. Check whether the connection of vertical post and burner are
3 espaciadores de reflectores.
tightened.
assembled according to instructions, and all bolts and nuts are
5-2. Put 3 pcs Large Flat Washers on 3
tightened.
5-2. Put 3 pcs Large Flat Washers on 3
STEP 6
PASO 6
Fije el reflector con 3 piezas de arandelas planas grandes y
STEP 6
Fasten the reflector with 3 pcs Large Flat Washers and 3 pcs Wing Nuts.
3 piezas de tuercas de mariposa.
Fasten the reflector with 3 pcs Large Flat Washers and 3 pcs Wing Nuts.
Reflector Spacers.
Reflector Spacers.
- 8 -
- 8 -
PASO 4
STEP 4
STEP 4
Pernos
Bolt
Bolt
PASO 5
STEP 5
STEP 5
Reflector
Reflector Spacer
espaciador
Reflector Spacer
PASO 6
STEP 6
STEP 6
Tuerca
de mariposa
Wing nut
Wing nut
Reflector
Reflector
Reflector
49

Publicité

loading