Technical Features - Bartscher 285.102 Mode D'emploi

WARNINGS
General
x Read the instructions carefully before installation, use and maintenance of the appliance.
x The installation has to be carried out by qualified personnel following the manufacturer's
instructions in the specific manual.
x The appliance has to be used by trained personnel only and for the intended use only.
x In the event of breakdown or malfunctioning, switch off the appliance and call the after sales
assistance from an authorized centre only.
x Use original spare parts only; otherwise no liability is accepted by the manufacturer.
x The appliance must not be washed with high pressure water sprays, neither must the openings or
air fumes on heat inlets/outlets be blocked.
ATTENTION! The manufacturer declines any liability for damage caused by wrong
installation, tampering, making unauthorized changes, improper use, poor maintenance,
installation of non-original spare parts, not observing local norms, incorrect use or not
observing the instructions in this booklet
For the installer
x The functioning of the appliance has to be explained and shown to the user. After ensuring that
everything is clear, the instruction booklet has to be handed over to the user.
x The user has to be informed that any building modification or restructuring that may in any way
modify the air supply necessary for combustion makes it necessary to carry out another check of
the functionality of the appliance.
The following instructions for set up and functioning refer to gas and mixed appliances belonging to
categories I I
2H, 3P,
Buthane/Propane (G30-G31) of 30/50 mbar and Methane (G20-G25-G25.1) of 20/25 mbar. The
data plate (figg. 17, 18, 19 – pp. 10, 11) showing all the appliance information is to be found inside
the right or left side of the control panel, depending on the model.
The appliances have been checked in accordance with the European directives down below:
2006/95/EC - Low Tension (LVD)
89/336/EEC - Electromagnetic Compatibility (EMC)
90/396/EEC - Gas Appliances
98/37/EC - Appliance to the directives
2002/95 - Rohs
And the particular reference norms.
Declaration of compliance
The manufacturer declares that the appliances of their production meet the above mentioned EEC
directives and requires that installation be done observing the norms in force, particularly regarding
the system for letting out fumes and air exchange.

TECHNICAL FEATURES

I , II II
3B/P HS3B/P, 2E3PB/P
II , II , II
2H3+ 2H3B/P 2L3B/P
Pag. 73/130
with a power pressure for