Binding; Range-Checking The Radio System; Using The Dig Transmission - Horizon Hobby Axial SCX-10 III JEEP JLU WRANGLER Manuel D'utilisation

EN

BINDING

Binding is the process of programming the receiver to recognize the
GUID (Globally Unique Identifier) code of a single specific transmitter.
The transmitter and receiver are bound at the factory. If you need to
rebind, follow the instructions below.
1. Connect a fully charged battery pack to the ESC/receiver.
2. Disconnect the "Dig" servo lead from the receiver.
3. Press and hold the bind button on the receiver.
4. Power ON the receiver. The red LED flashes, indicating the
receiver is in bind mode. Release the bind button after the red LED
begins to flash. The motor will make continuous descending tones
until binding is complete.
5. With the throttle trigger at neutral, press and hold the transmitter
bind button while powering on to put the transmitter in bind mode.
The throttle should be at neutral to set failsafe.
6. The bind process is complete when the green LED on the receiver
remains lit.
7. Connect the "Dig" servo lead to the receiver.
You must rebind when different failsafe positions are needed e.g.,
when throttle or steering reversing has been changed.

RANGE-CHECKING THE RADIO SYSTEM

The radio system should be checked before operating the vehicle to ensure proper operation and adequate range.
1. Turn on the transmitter.
2. Connect the battery in the vehicle.
3. Have a friend hold the vehicle while keeping hands and loose clothing away from moving parts.
4. Walk away until you are at the maximum planned operating distance from the vehicle.
5. Turn the steering wheel side to side and operate the throttle, both forward and reverse, checking for any
erratic behavior.
6. If any erratic behavior is exhibited, DO NOT operate the vehicle. Call customer service for assistance.

USING THE DIG TRANSMISSION

The vehicle includes a "Dig" transmission which allows the rear axle
to lock while still allowing the front wheels to spin. Use this feature in
close quarters to turn the vehicle tighter than is possible with normal
4 wheel drive or to preload the suspension when needed.
To use the Dig function:
1. Press and hold the channel 3 B button on the transmitter. The Dig
function engages, locking the rear axle. Hold the B button as long
as you want the dig function to be engaged.
2. Advance the throttle and turn the steering wheel left or right to
tightly pivot the vehicle around.
3. Release the channel 3 B button to disengage the Dig function.
Power Button
8
Power Switch
Bind Button
Bind Button