Charge The Vehicle Battery; Install The Transmitter Batteries; Transmitter Functions - Horizon Hobby Axial SCX-10 III JEEP JLU WRANGLER Manuel D'utilisation

Masquer les pouces Voir aussi pour Axial SCX-10 III JEEP JLU WRANGLER:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EN

CHARGE THE VEHICLE BATTERY

Follow the manufacturer's directions for your charger to properly
charge the vehicle battery.
CAUTION: Only use chargers designed to charge the chosen
battery type. Using an incorrect charger or incorrect charger
settings could cause the battery to catch fire or explode.

INSTALL THE TRANSMITTER BATTERIES

This transmitter requires 4 AA batteries.
1. Remove the battery cover from the transmitter.
2. Install the batteries as shown.
3. Install the battery cover.
CAUTION: NEVER remove the transmitter batteries while the
model is powered on. Loss of model control, damage, or injury
may occur.
CAUTION: If using rechargeable batteries, charge only
rechargeable batteries. Charging non-rechargeable batteries
may cause the batteries to burst, resulting in injury to persons and/or
damage to property.
CAUTION: Risk of explosion if battery is replaced by an incorrect
type. Dispose of used batteries according to national regulations.

TRANSMITTER FUNCTIONS

Channel 3 Button (Dig Function)
Channel 3 Button (Dig Function)
A/B.
C.
Throttle/Brake
D.
Steering Wheel
E.
Steering Rate
Adjusts the end point of the steering
F.
Brake Rate
Adjusts the braking end point.
G.
Steering Trim
Adjusts the steering center point. Normally, the steering trim is
adjusted until the vehicle tracks straight.
H.
Throttle Trim
Adjusts the throttle neutral point
I.
SMART Battery Level Indicator
J.
Servo Reversing
To reverse the Throttle (TH) or Steering (ST) channel, switch
the position of the correlating switch—"N" is for normal, "R"
is for reverse.
K.
Throttle Limit
Limits throttle output to 50/75/100%
Select 50% or 75% for less experienced drivers or when you
are driving the vehicle in a small area.
L.
Power LED
• Solid red lights: Indicates radio connectivity and
adequate battery power
• Flashing red lights: Indicates the battery voltage is
critically low. Replace batteries
M.
Power Button
N.
Bind Button
I
J
K
L
M
N
A/B
6
H
G
F
E
D
C

Publicité

Table des Matières
loading

Table des Matières