Adjusting The Vehicle Battery Tray; Install The Vehicle Battery - Horizon Hobby Axial SCX-10 III JEEP JLU WRANGLER Manuel D'utilisation

ADJUSTING THE VEHICLE BATTERY TRAY

The battery trays may be adjusted to fit a wide range of battery sizes.
The rear battery tray is shown in the illustration. The side battery tray
is adjustable in the same manner.
To adjust the battery tray:
1. Loosen the four flathead screws shown in the illustration.
2. Slide the ends of the battery tray in or out to fit the desired battery.
3. Tighten the four flathead screws. Do not over-tighten the screws.

INSTALL THE VEHICLE BATTERY

The following steps show the installation of a standard size battery in the rear battery tray of the vehicle. If you wish to use a "shorty" style
battery, it should be installed in the side battery tray location.
Power
1. Power on the transmitter.
2. Remove the four body clips from under the body.
3. Pull out slightly on the bottom sides of the body while lifting it
from the chassis.
4. Place the battery in the battery tray. The battery tray length may
be adjusted to fit the battery as described in the previous section.
5. Secure the battery to the tray with the hook and loop strap.
6. Connect the battery to the ESC.
7. Power on the receiver/ESC.
8. Re-install the body and four body clips to the chassis.
NOTICE: Always power off the ESC and disconnect the battery
from the ESC before powering off the transmitter. Loss of vehicle
control may result.
7
EN