Black & Decker LM2000 Traduction Des Instructions Initiales page 13

Troubleshooting
If your appliance seems not to operate properly, follow the
instructions below. If this does not solve the problem, please
contact your local BLACK+DECKER repair agent.
Warning! Before proceeding, release the bail bar to turn
mower off and wait for the blade to stop .
Problem Possible solution
Mower doesn't run when Check to make sure mower is properly plugged
bail handle is activated.
in and that the button on switch box is being
completely depressed before pulling the bail
handle.
Release bail handle to turn mower off. Remove
safety key and battery pack, turn mower over
and check that blade is free to turn.
Motor stops while mowing.
Release bail handle to turn mower off. Unplug
mower. Turn mower over and check that blade
is free to turn.
Raise cutting height of wheels to highest posi-
tion and start mower.
Avoid overloading the mower. Slow down the
cutting pace, or raise the cut height.
Mower runs but cutting Release bail handle to turn mower off. Unplug
performance is unsatisfac-
mower. Turn mower over and check:
tory,
u
u
Wheel height adjustment may be set too low for
grass condition. Raise cutting height.
Mower is too hard to push. Release bail handle to turn mower off. Unplug
mower. Raise cutting height to reduce deck
drag on grass. Check each wheel for free
rotation
Mower is abnormally noisy Release bail handle to turn mower off.
and vibrates. Unplug mower. Turn mower on side and
check blade to ensure it has not been bent or
damaged. If blade is damaged, replace with
a BLACK+DECKER replacement blade. If
the underside of the deck is damaged, return
mower to a BLACK+DECKER Authorized
service center.
If there is no visible damage to the blade and
the mower still vibrates:
u
u
u
u
u
If mower still vibrates, return the mower to
an authorized BLACK+DECKER authorized
service center.
Mower not picking up Chute clogged. Release bail handle to turn
clippings with bag.
mower off. Unplug mower. Clear chute of grass
clippings.
Raise cutting height of wheels to shorten length
of the cut.
Bag full. Empty bag more often.
Protecting the environment
Z
Separate collection. Products and batteries
marked with this symbol must not be disposed of
with normal household waste.
Products and batteries contain materials that can be recov-
ered or recycled, reducing demand for raw materials. Please
recycle electrical products and batteries according to local
provisions. Further information is available at
www.2helpU.com
Blade for sharpness - Keep blade sharp.
Deck and discharge chute for clogging.
Release bail handle to turn mower off.
Unplug mower.
Disassemble entire blade assembly as
described in the "Removing and installing
blade" section.
Remove any debris and clean each piece.
Replace each piece as described in the
"Removing and installing blade" section.
(Original instructions)
Technical data
Voltage Vac
W
Power input
-1
min
No-Load Speed
Z
Impedence
MAX
kg
Weight
Hand/arm weighted vibration value:
= <2,5 m/s , uncertainty (K) = 1,5 m/s
2
L (sound preasure) 85 dB(A)
PA
uncertainty (K) = 2,5 dB(A)
EC declaration of conformity
%
MACHINERY DIRECTIVE
OUTDOOR NOISE DIRECTIVE
LM2000 lawn mower
Black & Decker declares that these products described under
"technical data" are in compliance with:
2006/42/EC, EN 60335-1:2012 + A11:2014,
EN 60335-2-77:2010
2000/14/EC, Lawn Mower, L < 50cm, Annex VI,
DEKRA Certification B.V., Utrechtseweg 310, ED Arnhem
Netherlands
Notified Body ID No.: 0344
Level of accoustic power according to 2000/14/EC (Article 12,
Annex III, L < 50cm, cm):
L (measured sound power) 95 dB(A)
WA
uncertainty (K) = 1,0 dB(A)
L (guaranteed sound power) 96 dB(A)
WA
These products also comply with directive 2014/30/EU and
2011/65/EU. For more information, please contact Black &
Decker at the following address or refer to the back of the
manual.
The undersigned is responsible for compilation of the technical
file and makes this declaration on behalf of Black & Decker.
Black & Decker Europe, 210 Bath Road, Slough,
ENGLISH
LM2000
230V
2000
3500RPM
0.4103
25.46
.
2
R. Laverick
Director of Engineering
Berkshire, SL1 3YD
United Kingdom
26/08/2016
13