Télécharger Imprimer la page

Black & Decker LM2000 Traduction Des Instructions Initiales page 11

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 25
Adjusting mower height (fIg. K)
The height of cut is adjusted by the central cut height adjust
lever, there are 7 positions to choose from.
Note: If you are not sure which height to cut, begin mowing
with the height adjustment lever (7) in position 7 and adjust
the height down as needed, as shown in figure K.
To set the height of cut:
Pull the mower height adjustment lever out of the locking
u
notch.
Move the lever towards the rear of the appliance to lower
u
the height of cut.
Move the lever towards the front of the appliance to raise
u
the height of cut.
Push the height adjustment lever into one of the 7 locking
u
notches.
Starting mower
Warning! Sharp moving blade. Never attempt to override the
operation of this switch box as serious injury
could result.
Your mower is equipped with a special on-off switch box.
u
To operate the mower, push the button (26) on the switch
box (1), then pull the bail handle (2) to the handlebar as
shown in Figure L. Release button and hold bail handle
with both hands.
To turn the mower off, just release the bail handle.
u
Warning! Never attempt to lock a switch or bail handle (2) in
the on position.
Note: Once the bail handle has returned to the original posi-
tion it will activate the "Automatic Braking Mechanism". The
motor is electrically braked and the mower blade will stop
rotating in 3 seconds or less.
Mowing (fig. M - N)
Warning! Always inspect area where mower is to be
used and remove all stones, sticks, wire, bones and other
debris which might be thrown by the rotating blade.
We recommend to use your mower as outlined in this section
in order to achieve optimum results and to reduce the risk of
cutting the main cable.
Place the bulk of the cable on the lawn, close to the start-
u
ing point (position 1 in fig. M).
Switch the mower on as described above.
u
Proceed as shown in fig. M.
u
Move from position 1 to position 2.
u
Turn right, stepping over the cable and proceed towards
u
position 3.
Turn left, stepping over the cable and move towards posi-
u
tion 4.
Repeat the above procedure as required.
u
Warning! Do not work towards the cable as shown in fig. M1.
EdgeMax™
EdgeMax™ (11) allows you to cut grass right up to the edge of
a wall or fence (fig. N).
EdgeMax™ allows you to accurately cut grass right up to the
edge of your lawn (fig. N1).
With the lawn mower parallel to the edge of your lawn,
u
push the lawn mower along the edge of the lawn. ensure
that the EdgeMax™ is slightly over the edge of your lawn
(fig. N1).
(Original instructions)
Note: When the side discharge attachment is attached
EdgeMax™ can only be used on the right side of the mower.
Mower overload
To prevent damage due to overload conditions, do not try to
remove too much grass at one time.
Slow down your cutting pace, or raise the cut height.
Storage
Warning! Rotating blade can cause serious injury. Release
bail handle (2) to turn mower off, remove safety key, and re-
move battery before lifting, transporting, or storing the mower.
Store in a dry place.
Warning! To avoid being pinched, keep fingers away from
area between handles when folding down handles.
Warning! Make sure cord does not become stretched or
pinched in the joints of the handles during folding. This can
cause damage to the cord.
The handle of the mower can be easily folded down for quick
and convenient storage.
Holding onto the handle, open, but do not remove, the
u
lower-handle attachment levers (6) and fold the handle to
the front of the mower as shown in figure O.
Open, but do not remove, the upper-handle attachment
u
levers (5) and fold the upper handle (3) back over the
lower handle (4) as shown in figure P.
The mower shold be compacted down as shown in
u
figure Q.
Keep all nuts, bolts, and screws tight to be sure the appli-
u
ance is in safe working condition.
Check the grass catcher frequently for wear or deteriora-
u
tion.
Replace worn or damaged parts for safety.
u
For rotary mowers, ensure that only replacement cutting
u
means of the right type are used.
Carrying the mower
The mower can be carried using the convenient carry
u
handles (10) as shown in figure R. DO NOT attempt to
lift the mower by grasping the upper handle (3) or lower
handle (4).
Mowing tips
Warning! Always inspect area where mower is to be used
and remove all stones, sticks, wire, bones, and other debris
which might be thrown by the rotating blade.
Warning! Mow across the face of slopes, never up-and-down.
Exercise extreme caution when changing direction on slopes.
Do not mow excessively steep slopes. Always maintain good
footing.
Release bail handle to turn mower "Off" when crossing
u
any gravel area (stones can be thrown by the blade).
Set mower at highest cutting height when mowing in rough
u
ground or in tall weeds. Removing too much grass at one
time can cause the motor to be overloaded and to stop.
Refer to troubleshooting guide.
If a grass collection bag (8) is used during the fast growing
u
season, the grass may tend to clog up at the discharge
opening. Release bail handle to turn mower off and
remove the safety key. Remove the catcher and shake the
grass down to the back end of the bag.
ENGLISH
11

Publicité

loading

Ce manuel est également adapté pour:

Lm2000-qs