Troubleshooting; Error Detection; Programming Errors (Blinking Led); Electrical Errors (Non-Blinking Led) - Rain Bird ESP-Me Manuel D'utilisation

Troubleshooting

Error Detection

The ESP-Me controller has built-in error detection that
can automatically generate an ALARM caused by an
essential programming error or if an electrical short
condition is detected.
The ALARM LED light on the ESP-Me controller front
panel will light up to indicate an alarm condition:

Programming Errors (blinking LED)

Error
No Start Times are set
No Run Times are set
No Watering Days are set BLINK
The ESP-Me controller will reset or clear when the error
is corrected.
b c
NOTE: The dial must be in the AUTO RUN position
for an ALARM message to appear on the display.
ALARM Error Message
LED On Display
BLINK NO START TIMES
BLINK NO RUN TIMES
NO WATER DAYS

Electrical Errors (non-blinking LED)

ALARM
Error
LED
Master Valve short SOLID
Station short SOLID
When an electrical error is detected, irrigation for the
affected station is cancelled and watering advances to
the next operable station in the program.
The controller will attempt to water the affected sta-
tion again at the next scheduled watering. Completion
of a successful watering will clear the error condition
associated with that station.

Clearing Electrical Error Alarms

Turn the dial to the AUTO RUN posi-
tion to view the error message on the
display. To clear the ALARM, press the
right arrow
Error Message
On Display
MASTER VALVE/PUMP WIRE
SHORTED OR HIGH CURRENT
STATION "X" WIRE SHORTED
button.
ESP-Me Controller
ENG
31