C.P.Bourg Binding System BB3000 Mode D'emploi page 9

OPERATING INSTRUCTIONS
Program 3: Padding (no clamping but automatic pad ejection).
Preliminaries
Loading
Sheets clamping
Start of the process
Notching / milling
Glueing
Carriage opening
Pad dropping
Carriage return
* A change of binding mode during operation requires the full stop of the binder ( emergency (12) ).
Glue with short open time corresponds best to program mode 3, for occasional padding switch to
program 4.
*** Check the first pad. Change the settings if necessary . - In case of jam, lights in (10) flash.
Press them to allow the return of the carriage to the start position.
Attention ! : Lifting the plexi cover or pressing the emergency stop button stops the glue heaters.
To be able to work again quickly: release emergency knob and switch on the glue roller
immediately, otherwise it will cool down and take time to warm up again to operational
temperature.
- Switch "on" (9) the binder.
- Select (21) programme mode n° 3. *
- Switch "on" (17) the drum heating.
- Option : Select (8) for each day of one week the time that
the machine will automatically switch to stand by condition.
- The binder is ready to operate when the green lights in
buttons (10) are on.
- Switch "on" (16) jogger (unless footswitch option is used).
- Select (18) when notching/milling is required.
- Eventually adjust (7) milling depth.
- Select (20) notching/slitting density.
- Select (19) carriage pre-opening
memory closest to pad thickness
- Insert the sheets at the left end of the
openingof the carriage (spine downwards).
Their jogging is automatic if (16) is selected.
- When pressing both the carriage closure buttons
(10 & 10').
- Automatic when (10 & 10') are released.
- Automatic if (18) is selected. (green light on)
- Automatic.
- Automatic. (Cooling time is adjustable (22)).
- Automatic. ***
- Automatic.
May 1996
GB/ 5