AEG FAVORIT 99709 M0P Notice D'utilisation page 22

22 www.aeg.com
Problem
The appliance does not drain the
water.
The display shows the message:
Appliance is not draining water.
The anti-flood device is on.
The display shows the message:
Appliance is flooding or has an
error in the water inlet.
The appliance stops and starts
more times during operation.
The programme lasts too long.
The remaining time in the dis-
play increases and skips nearly to
the end of programme time.
Small leak from the appliance
door.
The appliance door is difficult to
close.
Rattling/knocking sounds from
inside the appliance.
The appliance trips the circuit-
beaker.
Refer to "Before first use",
"Daily use", or "Hints and
tips" for other possible
causes.
Once you have checked the appliance,
deactivate and activate the appliance. If
Possible cause and solution
• Make sure that the sink spigot is not clogged.
• Make sure that the filter in the outlet hose is not
clogged.
• Make sure that the interior filter system is not clog-
ged.
• Make sure that the drain hose has no kinks or
bends.
• Close the water tap and contact an Authorised Serv-
ice Centre.
• It is normal. It provides optimal cleaning results and
energy savings.
• Select the TimeSaver option to shorten the pro-
gramme time.
• If the delayed start option is set, cancel the delay
setting or wait for the end of the countdown.
• This is not a defect. The appliance is working cor-
rectly.
• The appliance is not level. Loosen or tighten the ad-
justable feet (if applicable).
• The appliance door is not centred on the tub. Ad-
just the rear foot (if applicable).
• The appliance is not level. Loosen or tighten the ad-
justable feet (if applicable).
• Parts of the tableware are protruding from the bas-
kets.
• The tableware is not properly arranged in the bas-
kets. Refer to basket loading leaflet.
• Make sure that the spray arms can rotate freely.
• The amperage is insufficient to supply simultane-
ously all the appliances in use. Check the socket
amperage and the capacity of the meter or turn off
one of the appliances in use.
• Internal electrical fault of the appliance. Contact an
Authorised Service Centre.
the problem occurs again, contact an
Authorised Service Centre.
For other alarm messages or problems
not described in the table, contact an
Authorised Service Centre.